Myblend GO Instructions

Smooth Blending

Smooth Blending

To make your blending experience as smooth as possible with Myblend, we recommend that you start by adding your liquids in first. This will allow the blades to work efficiently without getting jammed by any ingredients.

Smaller Pieces

Smaller Pieces

We recommend that you cut your fruits / ingredients to smaller pieces before blending.

Easy Blend

Easy Blend

As recommended, start by adding in your liquid of choice. Proceed to add the rest of your ingredients and blend until smooth! 

Frozen Fruit / Ice

Frozen Fruit / Ice

If you are blending a lot of ingredients / frozen ingredients or ice - start the blender upside down. Make sure the blades are completely free. Slowly flip the blender back up again so that all ingredients hit the blades in full speed.

Safety Precautions

Safety Precautions

Avoid at all times to put your hand inside of the blender. If the blender is being used by a child it should always be done by adult supervision. 

Don’t Run Empty

Don’t Run Empty

Don’t run your Myblend empty, doing so might damage the motor.

Cleans Like A Dream

Cleans Like A Dream

Myblend cleans itself! Just fill about half of the blender with water and a little bit of soap. Blend, and then rinse with cold water. 

Warm Liquids

Warm Liquids

We do not recommend blending liquids that are over 120​° ​F / 49 ​° ​C in your Myblend, since this may cause damages to the container and leakages to the base.

Jammed Blades

Jammed Blades

If you experience that the blender doesn't start when you have a lot of ingredients in it, it's because the blades are jammed. To resolve this, turn the blender upside down and give it a shake until all the ingredients are separated from the blades. Turn the blender on and slowly flip it back up again, so that all ingredients hit the blades in full speed. 

Not Aligned (Red & Blue Blinking Lights)

Not Aligned (Red & Blue Blinking Lights)

Red and blue flashing lights are a sign that the built in magnets in the container and base are not aligned. They need to be aligned for the blender to start. To resolve this issue, simply tighten the container a bit against the base. (The little arrow on the container should point down to the start button) 

Drying

Drying 

After you have cleaned your Myblend, detach the lid and the container from the base. Let every part air dry separately before mounting them back together. This will help keep your Myblend nice and clean and will prevent odors from getting stuck in the blender. 

x